Toner & drum help Brother HL-L3230CDW: reset a colour toner counter Use the physical Back and Cancel buttons, then plus to confirm the changed colour.
2 min read This is the button-panel procedure for HL-L3230CDW and the other listed LCD models. The HL-L3270CDW touchscreen uses a different confirmation step.
Use only after replacing the toner Fit a new, full, compatible toner cartridge before using this procedure. Resetting an empty or partly used cartridge will not refill it and will make its recorded life misleading. Keep the existing drum counter unchanged.
Check the local model and toner Models covered: HL-L3210CW, HL-L3230CDW. The Canadian family is TN223 standard / TN227 high yield. For a new TN227 cartridge, select that color’s HC entry.
Choose only the toner you replaced K or BK identifies black; C is cyan, M is magenta and Y is yellow. STD means standard capacity and HC means high capacity. Reset each newly replaced color separately; leave other toner and drum entries alone.
Reset after fitting the new toner 1 Keep the printer on and open the top toner-access cover after installing the new cartridge.2 Hold Back and Cancel together for one to two seconds. Release both, then immediately press Back again.3 Use plus/minus to highlight the replaced color and its installed capacity, such as M.TNR-HC for high-yield magenta. Press OK.4 At Reset/Exit, press plus. After Accepted appears, close the top cover. If the menu or message differs Stop if the listed controls or toner entry are missing. Close the cover and send Ink Hero your exact model, cartridge number and a photo of the message. A counter reset cannot repair a faulty chip or make the wrong cartridge compatible.
Help with a toner reset Technical references